News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

AWT-250

Started by Revor, Today at 10:47:49 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

Revor

Today at 10:47:49 AM
In process of doing upgrade on my Tormek 2000. Part of the upgrade is a AWT-250 trough. When fitted it is a tight fit sticks in the frame at the bottom rub point being where the magnet is. My previous trough which was a replacement for the very original grey one slides in and out with no problem. Because the AWT-250 sticks the jerkiness spills water defeating the reason of having it. I have callipered both troughs and the AWT-250 is just a 1 and a little bit mm wider. What is the manufacturing tolerance would a replacement be the same. Anyone any thoughts please.
Print
Go Up Pages1
User actions