News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

USB sticking in MB-102

Started by Rossy66, Today at 05:18:43 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

Rossy66

Today at 05:18:43 AM
I have started using my new MB-102 to sharpen chisels on the side and honing and it seems to be sticking when I turn the fine adjustment wheel. The wheel gets harder to turn after a few rotations and then stops and I can't raise the USB. If I lift the usb up and out of the MB-102 then reinsert it, it seems to work for a few turns and then seems to become difficult to turn the adjustment wheel again.

Does any one have any suggestions?
















?
Print
Go Up Pages1
User actions