News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Noobie Advice About Stones

Started by Dulcmrman, February 05, 2026, 02:00:02 AM

Previous topic - Next topic
Print
Go Down Pages 1 2
User actions

RichColvin

#15
Yesterday at 10:37:14 PM
I plotted the speed of the grinding surface vs. the diameter of the grinding wheel (for the T-8).  As shown in the chart, at 220mm, the speed is 88%, and at 180mm, it is 72%.
---------------------------
Rich Colvin
www.SharpeningHandbook.info - a reference guide for sharpening

You are born weak & frail, and you die weak & frail.  What you do between those is up to you.
Print
Go Up Pages 1 2
User actions