News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Need a Nose job

Started by FIGO, Today at 08:03:46 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

FIGO

Today at 08:03:46 PM
Hello!
I have squared off my bowl gouge nose. I am using a t8 with a 186r
hole A
protrusion 65
jig setting 3.

Attached shows my gouge on the right.
I'm trying to give it a fingernail grind like the one on the left...
Appreciate any advice to fix it in advance..
Print
Go Up Pages1
User actions