News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Is there still a wire burr at 200 Bess?

Started by ABall, July 20, 2025, 05:44:17 PM

Previous topic - Next topic

ABall

Thanks for link Ken, I have seen all his vids over the years and you just forget don't you. I was fixated on speed and when the composite wheel came out he did a vid going from CBN 160 (amongst a couple of other options) straight to composite. That was was probably when I stopped looking for improvement and I just stuck with it. He did also move onto green chromium oxide on the leather wheel, I never really tried that until I bought the Bess tester which is quite a few years later. I will have to go over the Globals at some point.