Tormek Angle Calvulator - Constant Value Verification Request

[getsharp]

Hello fellow grinders. I'm hoping someone can help me verify two required constant measurements when using angle calculators.

Are these measurements accurate?
Support Bar Offset: 50mm
Case Height: 30mm

Thank you in advance
Case Height

[cbwx34]

Usually use 50 and 29 (for a T-8)

You cannot view this attachment.

[tgbto]

And as mentioned often, measuring to the surface of the wheel eliminates the need for these intermediate measurements and associated errors.

Plus it is not really harder than measuring straight to the right spot on the casing.