News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Problems to sharpening a knife

Started by Hydrazin, March 15, 2025, 12:56:13 PM

Previous topic - Next topic

Hydrazin

Hello everyone,

I am having difficulties sharpening a chef's knife. I have three in total: a small Boker Damascus Black chef's knife with a VG10 cutting edge, a Boker Cottage-Craft chef's knife with a C75 blade hardened to 58 HRC and a Japanese Santoku from Goko Hamono with a Shirogami 1 steel cutting edge, which the manufacturer claims is hardened to 63 to 65 HRC. I sharpen the VG10 and the Shirogami 1 blade at an angle of 15°, the C75 at an angle of 20°.

To sharpen the blades, I use a Tormek T1 without a honing wheel for the actual sharpening. The "finish" is done using the Spyderco V-Sharpener with the fine rods and, if necessary, honing leather.

I achieve satisfactory results with the first two knives. However, the Japanese knife does not want to be really sharp and I currently have no idea what the reason for this could be. Does anyone have any advice?

Best regards
Hyde

John Hancock Sr

Quote from: Hydrazin on March 15, 2025, 12:56:13 PMThe "finish" is done using the Spyderco V-Sharpener with the fine rods and, if necessary, honing leather.

These appear to be Aluminium Oxide which is not suitable for high hardness Japanese knives. I would suggest that you deburr using the T1 wheel only, or a leather strop.