News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Sharpening drill bits

Started by Bestarius, July 28, 2008, 04:33:09 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

Bestarius

July 28, 2008, 04:33:09 PM
I know the Tormek stone is too soft to sharpen a carbide bit. However, it seems that sharpening regular bits is not recommended. I'm curious as to why this is so?

Jeff Farris

#1
July 28, 2008, 07:47:01 PM
It is not that the stone is not recommended for twist drills, it is that there is no jig available for the job.
Jeff Farris
Print
Go Up Pages1
User actions