News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

New T8 Black issue

Started by Nikos, July 09, 2024, 06:39:52 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

Nikos

July 09, 2024, 06:39:52 PM
Hello fellow grinders.
Just upgraded to a new T8 Black from a T4 and found that I cannot mount the DF-250 on the correct side. It easily mounts when I flip the wheel with the plastic wall on the outside but when I flip it over to the correct side (grit wall facing out) the bore won't go past the end of the shaft threading.
 
Checked for burrs on the inside but it feels smooth.

cbwx34

#1
July 09, 2024, 07:17:36 PM
Quote from: Nikos on July 09, 2024, 06:39:52 PMHello fellow grinders.
Just upgraded to a new T8 Black from a T4 and found that I cannot mount the DF-250 on the correct side. It easily mounts when I flip the wheel with the plastic wall on the outside but when I flip it over to the correct side (grit wall facing out) the bore won't go past the end of the shaft threading.
 
Checked for burrs on the inside but it feels smooth.


Probably need to contact Customer Support for this one.
Knife Sharpening Angle Calculator:
Calcapp Calculator-works on any platform.
(or Click HERE to see other calculators available)

Ken S

#2
July 09, 2024, 10:32:14 PM
I agree. (support@tormek.se)

Ken

Nikos

#3
July 10, 2024, 04:29:01 PM
Wolfgang replied, just sent him a video of the problem.

Columbo

#4
July 11, 2024, 01:50:57 AM
Yeah, same here with mine

Nikos

#5
July 11, 2024, 04:13:20 PM
Quote from: Columbo on July 11, 2024, 01:50:57 AMYeah, same here with mine
Interesting... might be a bad batch.
Print
Go Up Pages1
User actions