News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Sharpenig 1 3/4 Roughing gouge

Started by Bladerunner10k, March 06, 2023, 06:45:59 PM

Previous topic - Next topic

Bladerunner10k

Just wondering what holder to use for this large tool. It won't fit the standard holder. I have T8 withall the kits.  Thanks for any assistance.

Ken S

Welcome to the forum, Bladerunner.

1 3/4" is a large roughing gouge! My largest roughing gouge is a Sorby 1 1/4" which fits easily in the SVS-50 with the open seat. If your larger roughing gouge won't fit, I would either use the SVD-110 platform jig or rest your gouge on the support bar set fairly close to the grinding wheel. If your roughing gouge is just slightly too large to fit, you might try filing the SVS-50 or the open seat. If you go this route, don't file too much away.

Keep us posted.

Ken