News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Is my kj-45 faulty?

Started by Rimu, February 01, 2023, 06:45:42 AM

Previous topic - Next topic

Rimu

My new kj-45 jig seems to bow in the middle. It's a bit hard to photograph, but to me the gap is less at the ends than in the middle. Anyone else see this? Will it have an effect?

Ken S

Rimu,

Your KJ-45 is not defective. The slight bow in the middle is an intentional design feature. Cabinetmakers often use the same principle to edge joint boards for glue joints. It is called a spring joint. When clamped, it allows a tighter fit. With the Tormek knife jigs, both the newer KJ jigs and the previous SVM jigs, it places the maximum clamping pressure to the ends of the clamp.

Ken