News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Large Hamlet Roughing Gouge sharpening

Started by Dweiss2, December 29, 2022, 12:54:39 AM

Previous topic - Next topic

Dweiss2

I have this huge Hamlet roughing gouge and it will not fit in the SVS-50 because the sides (wings?) are too tall. And I can't remove the V holder because then the holding screw will not reach the bottom. Tried the platform but that seemed sketchy. Any ideas?

RichColvin

---------------------------
Rich Colvin
www.SharpeningHandbook.info - a reference guide for sharpening

You are born weak & frail, and you die weak & frail.  What you do between those is up to you.

Ken S

Dweiss,
Take your SVS-50 to your hardware store. In the drawers of hardware, you should find M6 thread locking knobs. Find one long enough to reach the bottom of your jig. That should solve your problem.
(M6 is the commonly used thread size for many Tormek parts.
Ken