News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Extra fine adjuster?

Started by JustADudeInSweden, February 02, 2022, 11:51:15 PM

Previous topic - Next topic

JustADudeInSweden

Anybody have any experience with this product and it's claim of 1200-1500 extra fine grit?

https://knivslip.nu/produkt/stenjusterare-extra-fine/
Getting Jiggy With It

Ken S

You can do essentially the same thing with your stone grader. Use the fine side of the stone grader for the recommended time. Run your fingers over it. Then use your fine side again for a substantially longer time. (Try 90 seconds)
Your grinding wheel will feel smoother.

Ken

JustADudeInSweden

Does it help much in the end? ::)
If you were to guess how many BESS points would drop?
Getting Jiggy With It

Herman Trivilino

Quote from: JustADudeInSweden on February 03, 2022, 10:07:15 PM
Does it help much in the end? ::)
If you were to guess how many BESS points would drop?

Impossible to say, because it depends on too many other factors such as the type and condition of the steel and the edge.

Also, you might get it really sharp for showing off, but then when you go to use it, it can lose that keen edge quickly.
Origin: Big Bang

JustADudeInSweden

Yup, finding that sweet spot between wicked edge and lasting edge takes some experience...
Getting Jiggy With It