News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Sharp enough for stock diamond/leather wheels ?

Started by Artis, February 12, 2021, 08:57:59 AM

Previous topic - Next topic

Artis

This is my ~10th knife I did on my new T8.

I have all three diamond wheels and for all of them I did progression from coarse (grind while signs of burr) -> fine (2-3 passes) -> extra fine (2 passes) and finishing on leather wheel with Tormek paste.
All knives were previously done on worksharp ko blade grinding attachment.
Probably did not have to use coarse wheel, but wanted to run in diamond wheels before jumping on more expensive knives.

Around 8 knives out of 10 could slowly slice/cut Rizla Green paper both horizontally and vertically.

Here is photo of what my 15dps victorinox pocket knife can do to free standing hair. I left 2-3cm of hair free standing and tried to cut it. With steeper angle it cut it clean but when slicing at 10-20 angle it did what's in photo.

I guess it's sharp enough ?

Not bad for stock Tormek and such a toothy edge.

Ken S

Artis,
Not bad....for a beginner.
Just kidding.Well done; keep up the good work!
Ken