News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Second Use - 13" blades

Started by Byron, October 06, 2006, 08:02:24 PM

Previous topic - Next topic

Byron

I just finished my second session sharpening 13" DeWalt blades.  It occurred to me that no where can I find which grit to use.  I have been doing the 220/1000 method.  Is 1000 good enough?  Presumably, if the sharpening has been done correctly there is nothing left to sharpen without a readjustment.  None of these edges exhibited nicks.  If they did I am sure there just would not be enough blade material to remove them.  Your hint about honing using the holder was brilliant!  Thanks.

Jeff Farris

I would use both 220 and 1000.
Jeff Farris