News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

T-4 Arbor run out

Started by helldan211, April 09, 2020, 06:04:34 PM

Previous topic - Next topic
Print
Go Down Pages 1 2
User actions

helldan211

#15
April 21, 2020, 03:21:29 AM
UPDATE:    I have been doing a lot of sharpening and have not taken the stone off of the arbor.  As a result, I am not seeing much if any wobbling up and down.  By taking the stone off to measure it and not having it referenced and indexed, it must have contributed to the stone needing to be graded more often.  I have calipers that can measure the stone without taking it off now.  I previously was using a combination square.  BTW, I love this machine.

Dan

John_B

#16
April 21, 2020, 05:21:12 AM
Good to hear it is working out for you.
Sharpen the knife blade
Hone edge until perfection
Cut with joy and ease
Print
Go Up Pages 1 2
User actions