News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Anglemaster tip

Started by Ken S, February 07, 2020, 03:10:02 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

Ken S

February 07, 2020, 03:10:02 PM
I just picked up an interesting tip from one of Ron Robertson's you tubes. Ron loosens the angle setting screw on his Anglemaster just a little. This lets the angle dial "float" flat against the too surface while making adjustments.
Good idea, Ron.

Ken
Print
Go Up Pages1
User actions