News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Tormek should release a jig like on the T-2 for the T-8 and T-4

Started by CopperFish, April 16, 2024, 06:31:00 PM

Previous topic - Next topic

CopperFish

It seems like it should be straight forward to create a knife jig like the T-2 uses that would work on the T-8. This would save a lot of time when sharpening multiple knives in a single session.

I'm sure the T-2 jig isn't out of the box compatible with the T-8 but I'm sure they could design a similar jig that would work.

Ken S