Which jig for this blade?

[Cyrano]

This is a blade from a specialized utility knife. To sharpen its entire length requires taking it out of its handle, which prevents using the SVM-00.

Which jig would be best to sharpen this blade?

TIA,
Tony

Plan view:



Side view:

[cbwx34]

A razor blade has the same width (around 18mm)... and I can clamp it in the standard knife jig, with plenty of clearance.

So, I say SVM-45... unless I'm missing something here.

If you want to match the angles... you'll (obviously) have to set each side individually.

[Cyrano]

cb,

You're not missing anything. I'm missing my higher cognitive functions. 

For some inexplicable reason, it appeared there wouldn't be sufficient clearance -- but as you pointed out, there is.

Thanks,
Tony

[cbwx34]

cb,

You're not missing anything. I'm missing my higher cognitive functions. 

For some inexplicable reason, it appeared there wouldn't be sufficient clearance -- but as you pointed out, there is.

Thanks,
Tony

Hope it works!