News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Jigg for axs

Started by Haldor, February 23, 2018, 05:47:30 PM

Previous topic - Next topic

Haldor

is there anyone with a good idea of ​​a jig for such axes

cbwx34

Quote from: Haldor on February 23, 2018, 05:47:30 PM
is there anyone with a good idea of ​​a jig for such axes

Tormek has an ax jig, the SVA-170... seen HERE ... for axes.

Or are you looking for something else?
Knife Sharpening Angle Calculator:
Calcapp Calculator-works on any platform.
(or Click HERE to see other calculators available)

Haldor

sva 170 is for normal axes with about 10-20 cm length of ax head.These axes on the picture are 20-40cm long. So the 170 jig comes for the stone, so I do not get the right angle on the edge.

cbwx34

Quote from: Haldor on February 23, 2018, 06:09:10 PM
sva 170 is for normal axes with about 10-20 cm length of ax head.These axes on the picture are 20-40cm long. So the 170 jig comes for the stone, so I do not get the right angle on the edge.

Ah... cool.

Only thing I can think of (I'm not an ax sharpener though) is Herman's  "Knife Rest" jig... might work for what you're looking for.  Here's the thread...

https://forum.tormek.com/index.php?topic=1592

... and a video on how it works...

https://youtu.be/AcWAkQmoU8c

...if this doesn't work, I'm sure an actual "ax sharpener" will be along to help out. ;)

You might also look at this thread for some ideas...

https://forum.tormek.com/index.php?topic=3448

... about 1/2 way down the first page, there's a post where Jan uses a clamp instead of the ax jig.  (Might spark some ideas).

Hope that helps. :)
Knife Sharpening Angle Calculator:
Calcapp Calculator-works on any platform.
(or Click HERE to see other calculators available)