mortise chisels - how?

[Greg_R]

I have some 'real' mortise chisels that are taller than they are wide.  They look very similar to these.  How should I go about sharpening them on the Tormek?  It seems to me that the face of the edge would develop a large cup after grinding (may not be good for mortise-type cuts).  Thoughts or suggestions?

[Jeff Farris]

The curve introduced by the TORMEK stone is not enough to cause you a problem, even on mortise chisels.  That said, you can use the SVD-110 and lay the chisel on its side to grind a flat bevel.