News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

XB-100 Horizontal Base

Started by Elden, April 04, 2013, 01:03:48 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

Elden

April 04, 2013, 01:03:48 AM Last Edit: April 04, 2013, 01:06:22 AM by kb0rvo
Has the machined version of the XB-100 Horizontal Base always had 2 locking knobs or was there an earlier version with 1 knob?

Sorry, I meant to post this in the general topic area. ::)
Elden

Jeff Farris

#1
April 04, 2013, 03:51:11 PM
Working strictly from memory, there have been three versions of the XB-100.  The original was an extrusion with a single lock. The second was an extrusion with double locks. The third and current is cast and machined with double locks. There might have been two versions of the extruded with double locks, but if so, one of them was very short lived.
Jeff Farris

Elden

#2
April 04, 2013, 05:31:10 PM
Thank you Jeff for the reply and answers. Also, thanks for moving the post. I wasn't paying close enough attention.
Elden
Print
Go Up Pages1
User actions