News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

sleeve position in gouge grinding jig

Started by Sergio, December 04, 2012, 03:03:48 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

Sergio

December 04, 2012, 03:03:48 AM
Hello everibody, I have a question regarding the gouge sharpening jig: The position of the sleeve is important for a reliable and constant presentation of the gouge to the stone but the jig is lacking a way to repeat a position. In other words, is there a way to consistently set the sleeve in the same position?
Print
Go Up Pages1
User actions