News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Honing an Ellsworth Grind

Started by gat54, May 29, 2012, 07:45:21 PM

Previous topic - Next topic

gat54

Similar problem on an earlier topic; I can grind the bowl gouge but when I try to hone it, the righ wing extends to far left of the honing wheel to be dressed.  Same setup as grinding (75mm, JS=6, back hole on TTS)

George Taylor

Jeff Farris

Skip the jig altogether for honing. Use the profiled wheel to get the burr off, freehand the bevel for a few seconds, and get back to the lathe.
Jeff Farris

gat54

That was what I was planning; just wanted to be sure I hadn't missed anything.

Thanks Jeff

George