News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Length of tool support

Started by duke-one, April 07, 2005, 04:01:48 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

duke-one

April 07, 2005, 04:01:48 PM
Hello: I sometimes run out of length on my tool support. Is this something I'm doing wrong or would a longer rod be useful. KDM
Print
Go Up Pages1
User actions