News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

SVD-185 - any suggestions for a tool holder for large gouges?

Started by jeffmuscatine, April 18, 2012, 09:27:03 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

jeffmuscatine

April 18, 2012, 09:27:03 AM
Hello -

I have a large roughing gouge (Crown specs as 3/4") that does not fit into the tool holder of the SVD-185 jig.  Any suggestions?

Jeff
Jeff

jeffmuscatine

#1
April 18, 2012, 07:53:15 PM
Seems the SVS-50 will work on the Work Sharp 3000 with the tool bar attachment.

Jeff
Jeff

Jeff Farris

#2
April 19, 2012, 01:00:14 AM
The SVD-185 would not be appropriate for a roughing gouge. You want the straight across grind delivered by the SVS-50.
Jeff Farris
Print
Go Up Pages1
User actions