Camber Jig

[Mark Spaulding]

Jeff,

Any news about a Tormek Camber Jig for irons? I know that Jet came out with one for their machine and was wondering if Tormek had any plans for one.

Thanks.
Blessings,
--Mark

[Jeff Farris]

You don't need a jig to put a camber on your irons.  Just spend a few extra seconds with the left edge of the iron on the right side of the stone, and with the right edge of the iron on the left side of the stone. From what I have seen of the Jet jig, it will put far too much camber on an iron, you only want a little.

[Mark Spaulding]

Thanks Jeff,

I will have to give it a try. I have not had much success so far, but maybe I am not on staying long enough.

Thanks for the great support--one of the reasons I purchased my Tormek at Sharptools!

Blessings,
--Mark